Design Procedures for Amine System
Materials of Construction
Amine systems are extremely corrosive due to the acid-gas concentrations and the high temperatures. It is important that all carbon steel exposed to the amine be stress-relieved after the completion of welding on the particular piece. A system fabricated from stress-relieved carbon steel for DEA solutions, as recommended, will not suffer excessive corrosion. For MEA [...]
19Sep2009 | admin | Comments Off | ContinuedAmine Solution Purification
Due to side reactions and/or degradation, a variety of contaminants will begin to accumulate in an amine system. The method of removing these depends on the amine involved.
When MEA is used in the presence of COS and CS2, they react to form heat-stable salts. Therefore, MEA systems usually include a reclaimer, The reclaimer is a [...]
Amine Cooler
The amine cooler is typically an air-cooled, fin-fan cooler, which lowers the lean amine temperature before it enters the absorber. The lean amine entering the absorber should be approximately 10°F warmer than the sour gas entering the absorber. Lower amine temperatures may cause the gas to cool in the absorber and thus condense hydrocarbon liquids. [...]
19Sep2009 | admin | Comments Off | ContinuedRich/Lean Amine Exchanger
Rich/lean amine exchangers are usually shell-and-tube exchangers with the corrosive rich amine flowing through the tubes. The purpose of these exchangers is to reduce the reboiler duty by recovering some of the sensible heat from the lean amine.
The flow rates and inlet temperatures are typically known. Therefore, the outlet temperatures and duty can be determined [...]
Overhead Condenser and Reflux Accumulator
Amine-stripper overhead condensers are typically air-cooled, fin-fan exchangers. Their duty can be determined from the concepts in Chapter 3 as required to cool the overhead gases and condense the overhead steam to water. The inlet temperature to the cooler can be found using the partial pressure of the overhead steam to determine the temperature from [...]
19Sep2009 | admin | Comments Off | ContinuedAmine Stripper
Amine strippers use heat and steam to reverse the chemical reactions with CO2 and H2S, The steam acts as a stripping gas to remove the CO2 and H2S from the liquid solution and to carry these gases to the overhead. To promote mixing of the solution and the steam, the stripper is a trayed or [...]
19Sep2009 | admin | Comments Off | ContinuedAmine Reboiler
The reboiler provides the heat input to an amine stripper, which reverses the chemical reactions and drives off the acid gases. Amine reboilers may be either a kettle reboiler or an indirect fired heater.
higher the reboiler duty, the higher the overhead condenser duty, the higher the reflux ratio, and thus the lower the number of [...]